Not logged inRybka Chess Community Forum
Up Topic Rybka Support & Discussion / Rybka Discussion / Getting CB to reconize Rybka
- - By NM (*) Date 2008-11-21 08:36
Ok I had Rybka (64 bit non multiprocessor) running in CB fine. Just realized it was the 64 bit non-multi. So i delete those files. I then took the 64 bit multi rybka files and moved them into c/programfiles/chessbase/engines where the other files used to be.

I followed the normal steps to make it a uci engine. It all seems fine, I can see the Rybka 3 . uci file, in C:programfiles (x86)/chessbase/engines.

However if I go to CB 9 and do file new board. Then engines add a kibitzer non of the rybka engines are listed. I am totally stumped. If I go to Fritz9 gui i have the same problem. Fritz, Hiarcs, crafty etc are all listed, and I can use them just fine.

Thank you for the help
Parent - - By Harvey Williamson (*****) Date 2008-11-21 08:47
Just create uci again in CB9.
Parent - - By NM (*) Date 2008-11-21 08:54
I did, and it creates it fine. however When I go to chessbase, open a new board, and then do engines add a kibiter rybka is not listed. However if I open the engines folder the rybka. uci is right in the folder
Parent - - By keoki010 (Silver) Date 2008-11-21 15:03
Do a search for rybka on the C: drive.  The .uci and exe's could be in several different places including some hidden files.
Parent - - By NM (*) Date 2008-11-21 19:16
Both the .uci and the .exe are in the engines folder.
Parent - - By NM (*) Date 2008-11-21 19:43
Also Rybka 2.3.2. uci is in the folder and it also is not being read.

I have no idea what happened this is very frustrating.
Parent - By NM (*) Date 2008-11-22 02:47

Well I kept making .uci engines. I have 5 rybka 3 in my engines folder right now. Finally Rybka 3 is an option when i open up a new board in CB9.

I have no idea why but it works so I am happy.

Up Topic Rybka Support & Discussion / Rybka Discussion / Getting CB to reconize Rybka

Powered by mwForum 2.27.4 © 1999-2012 Markus Wichitill